Pages

Sunday, March 24, 2013

Browse » home» » » » » » Chrysler HEMI BB Installation Manual

Chrysler HEMI BB Installation Manual

Chrysler HEMI / BB Installation Manual For Systems with A/C. Disconnect battery; remove all existing accessory drive brackets and components from motor. Remove water pump and housing, scrape away any existing gasket material with a gasket scraper and dress surface with a Scotch Brite® pad. Clean and prep threads on engine block at water pump, use a 3/8-16 thread chaser if necessary. Thread chasers are available at your local auto parts store or tool dealer and are different from a thread cutting tool. Apply RTV sealer to one end of the 3/8-16 x 3” threaded stud and thread stud into the driver side top water pump mount hole. Next apply RTV sealer to one end of the 3/8-16 x 4-1/4” stud and thread into the lower driver side mount hole and tighten. Apply RTV sealer to one end of the remaining 3/8-16 x 3-1/2” stud and thread into the bottom passenger side mount hole and tighten. The studs can easily be tightened by threading two 3/8-16 zinc coated nuts onto the stud and tighten them against each other to act as a drive nut*. Apply anti-seize the exposed threads of the studs at this time. Check installed height of studs by sliding water pump housing on to the studs. There should be 1/2” of exposed threads on the top stud and 1” of exposed thread on the bottom studs.

Get from here to download Chrysler HEMI / BB Installation Manual

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.